THE TAPERED STRIPS CHALLENGE
How many of these strips does your nesting software fit on this remnant?


THE JOB

Parts   150 tapered strips, 990 mm long, 80 mm wide at one end and 40 mm at
        the other (a symmetric trapezoid, 0.0594 m2 each).
        parts/tapered-strip-990x80-40.dxf and .svg

Sheet   One remnant, 4800 x 2400 mm, with:
        - a notch in its right edge, 680 x 1150 mm (x 4120-4800, y 650-1800);
        - a cut-out of 1900 x 1250 mm with 100 mm corner radii
          (x 900-2800, y 600-1850);
        - four round holes of 200 mm, centred at (350, 350), (350, 2050),
          (4450, 300) and (4450, 2100).
        8.24592 m2 of material.
        sheet/remnant-side-notch-4800x2400.dxf and .svg

Goal    As many strips as fit on the one remnant.

Rules   0 mm between parts, 0 mm kerf, no edge margin: strips may touch each
        other, the remnant's edges and the edges of its holes. Nothing goes
        over the notch, the cut-out or the holes.
        Turns: parts may be turned. Mirroring changes nothing (the strip is
        symmetric). Please say which turns and rules your software used with
        your result.

Millimetres throughout, origin at the remnant's bottom-left corner, y up. SVG
counts y downwards, so the SVG drawings are flipped to look like the DXF ones.


VELMAR CUT: 125 OF 150 (90.0 %)

Velmar Cut placed 125 of the 150 strips.

125 x 0.0594 m2 = 7.4250 m2 of the remnant's 8.24592 m2: 90.0 %.

Checked apart from the program: no strip overlaps another, and none lies off
the remnant or over its notch, cut-out or holes (arcs measured to within
0.001 mm).

velmar-cut-125/layout-125-of-150.dxf          the layout: the remnant on
                                              layer STOCK, the strips on PARTS
velmar-cut-125/layout-125-of-150.svg          the same as a picture
velmar-cut-125/layout-125-of-150-corners.csv  each strip's four corners


The drawings are free to use for testing and comparing nesting software.
